10/27/2022 0 Comments Accufast tabber parts![]() Need a parts breakdown/parts manual? Try Accufast KT Parts Break Down with Links! (Revision A) Find the part, click on it, and order! #Accufast tabber parts manual#Operators Instruction Manual for the Accufast KT 1.5 Dual Mode Tabber Need Tabs / Wafer Seal that work well with the Accufast Tabbers? Try Your sensor has now been re-calibrated! Another thing to check is to make sure the tabs are threaded correctly!īelow Shows to correct way to thread the Accufast KT Tabberĭo you need a KT? Give All For Mailers a call at 86 New and Used Accufast KT is available! Once you have this area clean turn the KT back on and,ģ) Toggle CLEAR TAB off and wait, a few secondsĥ) Toggle ON/OFF until a tab advances to the peel point and the TAB READY light illuminates. ![]() The sensor is on the bottom of the white housing and directed down at the lower sensor. In the photo below, look for the rectangle with the nut on it. If you remove the tabs and look from the exit side, you can see the top portion of the sensor. (The black circle in the white plastic, see photo below) Accufast Photo Sensor, 05-0559-00Ĭlean it off with some compressed air that is rated for sensors and electronics.Īlso, make sure no tabs are anywhere in the path. If you look inside the hole, you will see the bottom portion of the sensor. On the product entry side, there is an elongated hole under where the tabs peel off, see below TAB IS ACTIVATED, THE SENSOR’S DEFINITION ![]() If you experience tabbing problems on the Accufast KT, tune the sensor for clear tabs – translucent tabs Also known as a KT Sensor Reset: WARNINGĢ) Remove any tabs and debris from the peel point area through the INSPECTION WINDOW on the input end, below the threading path. How do I adjust and clean the Accufast KT Tab Sensor? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |